Body - Sunroof Won't Move To Lift Position
60 Sunroof doesn't move to lift position60 10 06
2018226/3
May 7, 2010
Supersedes Technical Service Bulletin Group 60 number 08-27 dated December 1, 2008 for reasons listed below.
Affected Vehicles
Condition
^ Sunroof cannot be opened to lift position when the switch is held in the pressed position.
^ If the switch is only pressed briefly, the function is correct.
Technical Background
Due to a software concern, the sunroof drive unit may lose its initialization.
Production Solution
Only sunroof drive units with modified software are installed at the factory.
Service
1. Replace the sunroof drive unit.
2. Perform initialization of sunroof drive unit. (Refer to ELSA service information.)
a. Close sunroof from the lift or slide position.
b. Pull and hold the sunroof switch in the down position (pulling the switch as if closing the sunroof from the vented position). After holding the switch in the down position for several seconds, the sunroof drive unit will click for several seconds.
c. While the drive unit is clicking, release the sunroof switch, and then again pull and hold the switch in the down position.
d. Continue holding the switch until all positions (sliding position fully open/closed/lift position fully open/closed) have been performed and the resistance values stored.
Warranty
Required Parts and Tools
The parts department only supplies sunroof drives with modified software.
Additional Information
All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service manuals for the latest information.