Holes For Telephone Handset Holder on Center Console, Drilling

Holes For Telephone Handset Holder On Center Console, Drilling

The center console is delivered as a replacement part without the holes for the cell phone retainer. The holes must be made later.

- Remove center console:
- Center console, removing and installing - USA and Canadian vehicles up to 10.04.
- Center console, removing and installing - USA and Canadian vehicles from 11.04.







- Create holes with the following dimensions.

a - 10 mm
b - 6 mm
c - 22 mm
d - 101 mm
e - 25 mm
f - 16 mm
g - 5 mm
h - 8 mm

- Clip the threaded hole piece from behind into center console and tighten cellular phone holder to 1.5 Nm.

NOTE: After installation, check whether the glove compartment will open.