Upper Rear Lid Trim, Removing and Installing

Upper Rear Lid Trim, Removing and Installing





1 Screws, (Qty. 2)

• Tightening specification 1.5 Nm

2 Upper rear lid trim

• Removal:

- Remove lower rear lid trim => [ (Item 3) Lower rear lid trim ].

- Remove bolts - 1 - (Qty. 2).

- Press spring clamps on trim sides off of rear lid (Qty. 4).

- Remove spring clips - 3 - on upper trim from rear lid (Qty. 4).

• Installing:

To install, perform the steps used in removal in reverse order. Observe the following when doing so:

- Before installing upper lid trim - 2 -, make sure rubber buffers - 4 - (Qty. 8) are installed.

- Guide upper rear lid trim behind rear lid side window frames.

- Clip in trim at top first and then at sides.

3 Spring clips (Qty. 8)

4 Rubber buffer (Qty. 8)