Airbag Adapter, Connecting

Power Front Memory Seats

• From 06.2006, the usual wiring harness routing to connector station under front seat. Refer to => [ Connectors, Disconnecting ] Front Seats has been replaced with modular wiring routing => [ Modular Wiring Routing Assembly Overview, from June 2006 ] Front Seats.

• The modular wiring routing has not been implemented for all countries.

• Check version of front seat and of vehicle and perform repairs accordingly.

• Note the two possible versions of the modular wiring routing, Modular Light or Modular. Refer to => [ Modular Wiring Routing Versions ] Front Seats.

Airbag Adapter, Connecting





• Before disconnecting ignition and ground wiring, technician must electrostatically discharge him/herself (touch door striker plate or pin briefly).

CAUTION!
The Airbag Adapter (VAS 6036) must stay connected to seat until seat is installed again.





1 - Seat Connector Power Supply Connector (Red)

2 - Current Supply - Airbag Adapter Connector (Red)

3 - Airbag Adapter Connector (Yellow)

4 - Airbag Connector (Yellow)

• Disconnect ignition and ground wiring.

• Connect the airbag connector - 4 - to the airbag adapter connector - 3 -.

• If present: Connect voltage supply connector for airbag adapter - 2 - to voltage supply connector for seat - 1 -.