Bearings D and E for Disc Set I

Bearings D and E for Disc Set I

Special tools, testers and auxiliary items required

• Thrust piece (VW 432)

• Seal driver-front wheel bearing (3158)

• Sleeve (T40088/2) from assembly device (T40088)

Removing

• Intermediate housing removed => [ Chain and Disc Set I Assembly Overview ] Chain and Disc Set I Assembly Overview

- Place the intermediate housing on two wood supports - arrows - so as not to damage the selector shaft and the sealing surface.





- Remove circlip - arrow -.





- Turn intermediate housing.





- Remove bearings "D" and "E" for disc set "I" using thrust piece (VW 432)- arrow -.

Installing

- Place intermediate housing on two wood supports - arrows - so as not to damage the selector shaft and the sealing surface.





• When removing, bearing "E" must always be replaced.

- Install new bearing "E" (ball bearing for disc set " I") - 1 - on the intermediate housing.





• The oil grooves in the outer bearing race face upward.

- Install bearing "E" (ball bearing for disc set " I") using (T40088/2) from assembly tool (T40088) and drift sleeve (3158) all the way in - arrow -.





- Install bearing "D" - 1 - (roller bearing for disc set "I") in the intermediate housing.





• Installation position: printed side faces up.

• Depending on the version, different bearings are installed:





A Bearing "D" with inner race
B Bearing "D" without inner race

- Install bearing "D" (roller bearing for disc set " I") using (T40088/2) from assembly tool (T40088) and drift sleeve (3158) all the way in - arrow -.





- Install circlip - arrow - and press it in further if necessary.