Rear

Rear Brakes, FWD, Assembly Overview





1 - Phillips-head screw - 4 Nm

2 - Brake disc

^ Never remove brake discs from hub by force. If necessary use penetrating fluid, otherwise brake discs can be damaged.
^ When worn always replace both sides

3 - Grease cap

4 - 12-point nut

5 - Wheel hub with wheel bearing and rotor

^ Only replace complete

6 - Bolt - 60 Nm

7 - Backing plate

8 - Stub shaft

9 - Parking brake cable

10 - Axle beam

11 - Speed sensor

12 - Hex head bolt

13 - Hex socket head bolt - 65 Nm

14 - Brake carrier

^ With guide pins and protective cap
^ Supplied as replacement part assembled with sufficient grease on guide pins
^ Install repair kit in the event of damage to protective caps; use pad provided to grease guide pins.

15 - Brake hose/line

^ With banjo bolt and seals
^ Replace if banjo bolt is loosened
^ Tighten banjo bolt to 38 Nm

16 - Bolt - 35 Nm

^ Self-locking
^ When loosening and tightening counter hold on guide pin
^ Replace each time after removing

17 - Brake caliper housing

18 - Brake pads

^ When worn always replace both sides

19 - Pad retaining springs

^ Always replace when changing pads