Engine Mounts, Adjusting

Engine mountings, adjusting

- Unbolt hydraulic fluid reservoir above right side engine mounting and pull to one side.





Distance -a- between engine console -1- and support arm -2- of right side engine mounting should be about 13 mm. It should be possible to insert a 12 mm flat iron bar without difficulty (e.g. special tool 2011).

If the gap is too narrow or too wide, proceed as follows:





- Remove air hose -4- from mass air flow sensor.
- Disconnect electrical connectors for mass air flow sensor -1-.
- Remove bolts -2- and -3- and remove air cleaner housing.





- Set up engine support 10-222A onto fender panel flanges with supports 1O-222A/1 and two spindles.
- Bolt retainer 3180 to right side lifting eye and engage on hook at end of right side spindle.
- Engage hook at end of left side spindle in left side lifting eye.
- Raise engine slightly, taking up weight evenly on both spindles.





- Loosen bolts -b- on left and right side support arms by about two turns each.
- Insert an iron bar between engine console and support arm, then move engine until gap -a- measures 13 mm.
- Tighten (by hand) all four bolts -b- on left and right side support arms.
- Tighten all four bolts to 85 Nm.