Code Control Module (Function 07) [ 2001 - 2003 ]

Code Control Module (Scan Tool Function 07)

If control module does not indicate coding corresponding to vehicle, or if control module has been replaced, code it as follows.

NOTE: Control module with Part No. 8N0 906 018 T was equipped with "06610" as a permanent code and cannot be re-coded.

- Connect VAS5051 tester or VAG1551 scan tool and select the control module for engine electronics using address word 01
Ignition must remain switched on for this.

Indicated on display:


Rapid data transfer HELP
Select function XX


- Press buttons -0- and -7- to select "Code control module" and press -Q- button to confirm input.

Indicated on display:


Code Control Module Q
Enter code number XXXXX (0-32000)


- Input control module coding according to code table.

Clarification of coding






- Confirm input using the -Q- button.


8N0906018T 1.8l R4/5VT G 0002 ->
Coding 06610 WSC 12345


VAG1551 Scan Tool (ST) display indicates control module identification, e.g.:

NOTE:
If indicated on display:


Function is unknown or ->
cannot be carried out at the moment


Either an unauthorized code number was entered or the control module is not capable of being coded.

- Press -> button.

Indicated on display (function selection):


Rapid data transfer HELP
Select function XX


Coding table