Procedures

Ignition key removal lock operation, checking, 02E, 6 Speed Direct Shift A/T, AWD

Note: Work through the following steps to arrive at - Ignition key removal lock is OK - at the end of Step 3.

Work sequence

Step 1
- Shift selector lever to - P -.
- Switch off ignition.
- Remove ignition key.
- Attempt to move selector lever out of - P -.

If selector lever cannot be shifted out of - P -, go to - Step 1 -.

If selector lever can be shifted out of - P - with button pressed:
- Check for a problem in adjustment of locking cable and correct if necessary. Then return to beginning of - Step 1 -.

If problem is not in adjustment of locking cable:
- Replace faulty selector mechanism or steering lock.

Step 2
- Depress brake pedal.
- Insert ignition key.
- Switch on ignition.
- Attempt to move selector lever out of - P -.

If selector lever cannot be shifted out of - P - with button pressed:
- Check for a problem in adjustment of locking cable and correct if necessary. Begin sequence again at - Step 1 -.

If selector lever can be shifted out of - P - with button pressed:
- Move selector lever to -R-, -N-,-D-, -S- in sequence.
- Attempt to remove ignition key from ignition lock.

If ignition key cannot be removed from the ignition lock, go to - Step 3 -.

If ignition key can be removed from the ignition lock:
- Check for a problem in adjustment of locking cable and correct if necessary. Begin sequence again at - Step 1 -.

Step 3
- Depress brake pedal.
- Move selector lever to - P -.

If ignition key can now be removed and the selector lever is locked in - P - position:
^ Ignition key removal lock is OK; checking procedure is completed

If the ignition key cannot be removed and/or the selector lever is not locked in - P -:
- Check for a problem in adjustment of locking cable and correct if necessary. Begin sequence again at - Step 1 -.