ABS/ESP ITT Mark 20/60

Diagnostic Trouble Code (DTC) memory (function 02), checking

Rapid data transfer HELP
Select function XX
Indicated on display (function selection)

- Press buttons 0- and 2- to select "Check DTC Memory", function 02.

Rapid data transfer Q
02 - Check DTC Memory
Indicated on display

- Press -Q- button to confirm input.

X DTC recognized
Number of stored DTCs or "No DTC recognized" will be indicated on display.

No DTC recognized ->

- Press -> button.

The stored malfunctions are displayed and printed out in sequence.

- Using the DTC print-out, repair malfunction as instructed in DTC table.

If "No DTC recognized!" is displayed, the program will return to "Select function XX" after the button is pressed.

Rapid data transfer HELP
Select function XX
Indicated on display (function selection)

- End Output (function 06).

Attention! ->
DTC Memory was not interrogated

If the following is indicated on the display

- DTC memory has not been checked.
- Select Check DTC memory (function 02).
- Switch off ignition and disconnect diagnostic connector.

Note:
Work procedure upon recognizing a malfunction:
1. Repair malfunction as instructed in DTC table.
2. Check DTC memory (function 02)
3. Erase DTC memory (function 05)
4. End Output (function 06)
5. Road test vehicle
6. Check DTC memory again