Removal and Replacement

Brake Lamp Switch, Removing and Installing

Note:
^ For a secure fit, the switch may only be installed once.

Removing

- Remove storage compartment on drivers side.
- Unplug electrical connector.
- Remove brake light switch by turning counter-clockwise 45 degree.

Installing

Install in reverse sequence; note the following points:





- Pull brake light switch plunger fully out (arrow).
- Install retainer tabs -1- and -2- on switch into recesses of installing hole and secure by turning clockwise 45 degree.

Note:
^ When installing brake light switch, do not operate brake pedal.
^ The plunger is adjusted automatically when the brake light switch is inserted.

- Make sure proper function of brake lights when brake pedal is pressed and released.