Clutch Pedal Switch F36 Removing and Installing (Bevel Housing)

Clutch pedal switch F36 removing and installing (bevel housing), 02M/02Y, 5 & 6 Speed M/T, AWD

Note: In order to assure secure fitting, switch must not be installed more than once.





Removing
- Remove driver side storage compartment.
- Disconnect electrical harness connector at clutch pedal switch.
- Remove clutch pedal switch - 1 - by rotating 90° toward left.





Installing
Installation is performed in reverse order of removal. Note the following:
- Remove plunger of clutch pedal switch completely.
- Press down clutch pedal by hand.
- Insert switch into assembly opening and secure by rotating 90° toward right - arrows -.
- Release clutch pedal.
- Install driver side storage compartment.