Installing

Installing
Installation is in reverse order of removal, note the following:





- Insert O-ring - A - with gear oil.
- Install cover on final drive.

Tightening torque: 25 Nm





- Clamp flange shaft in vise, using jaw protectors.
- Press circlip with new circlip - A - out of flanged shaft groove.
- Drive in flange shaft using a synthetic head hammer.
- Top off oil to lower edge of filler hole.
- Checking gear oil in rear final drive.
- Replace flanged shaft/drive axle seal (remove protective foil and push seal into joint).
- Install drive axle.