Gear Oil Level In Manual Transmission With Bevel Gear Transfer Case, Checking and Topping Off

Gear oil level in manual transmission with bevel gear transfer case, checking and topping off, 02M/02Y, 5 & 6 Speed M/T, AWD

Work procedure





- Remove locking bolt - arrow -.
^ Specified value: Oil level should reach lower edge of oil filler hole.
- Add gear oil if necessary.
- Thread in new locking bolt.

When filling again and after removing or installing bevel gear transfer case note the following:
- Remove locking bolt - arrow -.
- Fill up gear oil to lower edge of filler hole.
- Thread in locking bolt.
- Start engine, select gear and let transmission turn approx. 2 minutes.
- Stop engine and remove locking bolt.
- Once again, fill up gear oil to lower edge of filler hole.
- Thread in new locking bolt.

Tightening torque