CD Changer: Service and Repair

CD Changer (Roadster), Removing And Installing

The CD-changer is located behind the driver's seat inside of the rear wall trim.

Removing
- Remove left storage compartment.
- Remove clips in left storage compartment (1x)







- Remove remaining screws -2- (left and right, 3 screws each side) (2 Nm).
- Disconnect harness connector from CD changer.
- Remove CD changer from left storage compartment.

Installing
- Install in reverse order of removal.
- Always check harness connector after installing

Checking wiring connection between radio and CD changer
- Switch off radio.
- Press and hold MODE button on radio, and at the same time switch on the radio.
- Release MODE button.


1 - Wiring connection OK
Indicated on radio display:
"CONNECT" and "CD"
2 - Wiring connection not OK
Indicated on radio display:
"NO CDC"
- Check electrical connector on CD changer.
- Repeat wiring check, and if connection has still not been established check wiring according to wiring diagram.
See Electrical Wiring Diagrams, Troubleshooting & Component Locations