Safety Precautions

Safety Precautions

CAUTION: When doing any repair work, especially in the engine compartment, pay attention to the following due to clearance issues:
- Route all the various lines (e.g. for fuel, hydraulics, EVAP canister system, coolant, refrigerant, brake fluid and vacuum lines and hoses) and electrical wiring so that the original positions are restored.
- Ensure sufficient clearance to all moving or hot components.

Audi TT Coupe - If Test and Measuring Equipment Is Required During Road Test, Note the Following:
- Test and measuring instruments must be secured to rear seat and operated by a 2nd person from this location.

If test and measuring instruments are operated from the front passengers seat and the vehicle is involved in an accident, there is a possibility that the person sitting in this seat may receive serious injuries when the airbag is triggered.

Audi TT Roadster - If Test and Measuring Equipment Is Required During Road Test, Note the Following:
- Deactivate passenger-side airbag using key switch in glove compartment or via On Board Diagnostic (OBD)
- Activate passenger-side airbag after completing work.

To reduce the risk of personal injury and/or damage to the fuel injection and ignition system, always observe the following:
- Do not touch or disconnect ignition wires when engine is running or turning at starter speed.
- Only disconnect and reconnect wires for injection and ignition system, including test leads, when ignition is turned off.
- If engine is to be cranked at starting RPM without starting
- Remove fuses for voltage supply of ignition coils and for voltage supply of fuel injectors.