Rear Bumper

Rear Bumper

Special tools, testers and auxiliary items required

• Socket (T40078)






1 Rear Guide Piece, Front Section

2 Rear Guide Piece, Rear Section

3 Expanding Nut

4 Support for Loading Edge

5 Bolt

• 2 Nm

• T 25

6 Cross Member Bracket

• Not a replacement part, cannot be replaced individually, supplied with cross member delivery casing.

7 Bolt

• 23 Nm

8 Bumper Cross Member

• Bumper cover removed before removing.

• Remove bolts - 7 - and remove cross member toward rear.

9 Bumper Cover

• Tail lights removed.

• Bolting points, refer to => [ Rear Bumper Bolt Points ] Rear Bumper Bolt Points.

• Remove cap nuts (quantity: 2) from luggage compartment side using (T40078), refer to => [ Cap Nuts ] Rear Bumper Bolt Points.

• Remove TORX bolt - 10 - and sheet metal screw - 11 -

• Remove the three sheet metal screws on left and right wheel housing liner and bolts from cover from underside.

• First pull bumper cover at top out of guide pieces - 1 - or - 2 -, then pry over wheel housing liner and remove toward rear.

10 Bolt

• T 25

• 2.5 Nm

11 Metal Screw

• T 25

• 2.5 Nm

12 Combination Nuts

• 2 Nm

13 Spoiler Bracket

14 Bolt

• 2 Nm