Side Protective Molding

Side Protective Molding

• Heat side protective molding using hot air blower before removing.

• Clean adhesion surface with mineral spirits, treat with silicone remover and rub dry.

• Heat side protective molding to approx. 104 °F (40° C) using hot air blower before installing.

• Pull off protective foil, first fasten side protective molding, then press on forcefully using an application roller.





1 - Front Door Protective Molding

• Self-adhesive, insert into holes of door and press on.

2 - Rear Door Protective Molding

• Self-adhesive, insert into holes of rear door and press on.

3 - Double Sided Adhesive Tape

• Pull off protective foil before installing.