Glove Compartment Cover

Glove Compartment Cover

There are two versions of the glove compartment cover fastener. Both versions are described in the following.

• Version 2.

Version 1





- Remove glove compartment, refer to => [ Glove Compartment ] Glove Compartment.

- Remove joint pins on glove compartment cover brake component - 1 -.

- Remove pins - 1 - on left side of glove compartment.





- Open the glove compartment.

- Remove pins - 1 - on right side of glove compartment.





- Remove glove compartment cover.

Installation

To install, perform the steps used in removal in reverse order.

Version 2





- Remove glove compartment, refer to => [ Glove Compartment ] Glove Compartment.

- Remove joint pins on glove compartment cover brake component - 1 -.

- Remove pins - 1 - on left side of glove compartment.





- Remove glove compartment and remove inlay mat.

• There is a hole on the right side of the glove compartment in which the glove compartment cover pin is pressed.

• There is a cap on the right outer side of the glove compartment. - 1 -. Be careful not to loose the cap when removing the pin.

- Drive out the pin on the right side - 1 - with a Punch 4 mm from inside toward outside.





- Remove glove compartment cover.

Installation





Installation is reverse of removal, but note the following:

- Press cover cap - 1 - in correct position flush into glove compartment - 2 -.