Storage Compartment with Bracket

Storage Compartment with Bracket

Removing


• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Remove the seat. Refer to => [ Front Manual Seat ] Front Manual Seat.

- Secure the seat on the (VAS 6136).

- Open the storage compartment - 1 -.





- Push the opening stop - 3 - to the side and open the storage compartment all the way.

- Disconnect the storage compartment pivot, while doing this, carefully push the bracket - 2 - slightly to the side - arrow A -.

- Pull the storage compartment forward and out - arrow B -.

- Remove the bolts - 2 - and - 3 - on the side trim on the door sill side.





- Remove the bolts - arrows - and the bracket - 1 -.

Installation


• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

Installation is reverse of removal, but note the following:

• Ensure that electrical connections are pushed in as far as stop and engage with a click.


Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Disconnect the battery ground wire with the ignition switched on.

• If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.

Tightening specifications, refer to => [ Seat Pan and Seat Height Adjustment Unit Component Overview ] Seat Pan and Seat Height Adjustment Unit Component Overview.