Seat Height Adjustment Motor

Seat Height Adjustment Motor

Removing


• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Remove the seat. Refer to => [ Power Seat ] Power Seat.

- Secure the seat on the (VAS 6136). Refer to => [ Front Seat, Installing on VAS 6136 ] Front Seat, Installing on VAS 6136.

- Remove side trim on sill side. Refer to => [ Sill Side Trim ] Sill Side Trim.

- Remove side trim on tunnel side. Refer to => [ Tunnel Side Trim ] Tunnel Side Trim.

- Remove the backrest. Refer to => [ Backrest ] Backrest.

- Disconnect the electrical connector - 4 - on the seat height adjustment motor - 2 -.





- Disconnect seat pan upper frame - 1 - from lower frame - 3 -.

- Remove seat pan upper frame with cover and upholstery from lower frame.

- Remove the bolts - 2 -.





- Pull the height adjustment motor - 1 - toward the center of the seat and remove from the seat pan lower frame - 3 -.

Installation


• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Make sure the clip - arrow A - and plastic toothed segment collar - 2 - and the locking pins - B arrows - are inserted correctly in the holes on the fitting - 1 -.





- Make sure the plastic toothed segment is clipped to the fitting correctly.

• The plastic toothed segment collar - arrow C - must lie evenly on the fitting.

- Make sure the locking pins - A arrows - are inserted correctly in the holes - B arrows - on the link plate - 1 -.





Further installation is performed in reverse sequence of removal, but observe the following:

• Ensure that electrical connections are pushed in as far as stop and engage with a click.


Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Disconnect the battery ground wire with the ignition switched on.

• If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.

Tightening specifications, refer to => [ Seat Pan and Seat Adjustment Controls Component Overview ] Seat Pan and Seat Adjustment Controls Component Overview.