Operation CHARM: Car repair manuals for everyone.

Heated Oxygen Sensor and Oxygen Sensor Heater Before Catalytic Converter






Heated Oxygen Sensor and Oxygen Sensor Heater before Catalytic Converter

Special tools, testers and auxiliary items required

Ring Spanner 7-Piece Set (3337)

Removing

- Remove engine cover. Refer to => [ Engine Cover with Air Filter Element ] Service and Repair.

- Disconnect electrical harness connector - 1 - of the heated oxygen sensor (G39) and oxygen sensor heater (Z19).





- Remove oxygen sensor - arrow - using tool from (3337).





Installing

When installing, note the following:

New oxygen sensors are coated with assembly paste; the paste must not get into slots of oxygen sensor body.

For a used oxygen sensor, only coat threads with hot bolt paste. This paste must not come into contact with sensor slots. Hot bolt paste, refer to the electronic parts catalog ETKA.

Electrical wire of oxygen sensor must always be secured in the same position when installing so that contact with the exhaust pipe is avoided.

Tightening specification: 55 Nm