Throttle Position Sensor: Service and Repair

Accelerator Pedal Module With Throttle Position (TP) Sensors, Removing And Installing

Special tools, testers and auxiliary items required







- Release tool T10238

Removing







- Remove cover for steering column - arrows -.







- Disconnect electrical harness connector - 2 - , by pressing release button to stop - arrow -.
- Where necessary, pull wiring router - 1 - off from accelerator pedal module.
- Pry off cover using a screwdriver.
- Remove bolt.







- Push release tool T10238 into intended openings - arrow - up to stop, as shown, and remove accelerator pedal module.

Installing
- Tightening torque.

Installation is in reverse order of removal, note the following:







- Connect wiring router - 1 - and electrical connector - 2 - to accelerator pedal module - 5 -.
- The connector must engage audibly.
- Push accelerator pedal module onto securing studs - 6 -
- Insert centering pin - 7 - into hole on vehicle floor.
- Secure accelerator pedal module with bolt - 3 - and install cover cap - 4 -.