Oil Pressure Sender: Service and Repair

Oil Pressure Switch (F1)

Special tools, testers and auxiliary items required

• Assembly Tool (T10118)

• Socket 24 mm and Jointed Extension (T40175)

Removing

- Remove the noise insulation.

- Remove left charge air hose - 1 and 2 -.






- Remove the connector - 1 - from the bracket and disconnect the connector - arrow - from the oil pressure switch using the (T10118).






- Remove the oil pressure switch with the (T40175).






Installing:

• Tightening specifications, refer to => [ Oil Filter Bracket Overview ] Oil Filter Bracket Overview.

Install in reverse order of removal. Note the following:

• In the case of a 1-pin oil pressure switch, check whether the ground (GND) wire is connected.

• The hose supports, air guide pipes and hoses must be free of oil and grease before installing.

• Secure all hose connections with hose clamps appropriate for the model, refer to the electronic parts catalog ETKA.