Ribbed Belt Drive Component Overview

Ribbed Belt Drive Component Overview






1 Ribbed Belt

• Check for wear

• Do not kink

• Before removing, mark direction of rotation using chalk or felt-tip marker. Reversing the running direction on a used belt can destroy it.

• Removal and installation, refer to => [ Ribbed Belt ] Ribbed Belt

• When installing, make sure it is seated correctly on the pulleys

2 Vibration Damper

• With ribbed belt pulley

• Removal and installation, refer to => [ Vibration Damper ] Service and Repair

3 Bolt

• Replace

• 100 Nm plus an additional 180° turn

• Use counter-holder tool (T10069) to loosen and tighten

4 Bolt

• 20 Nm

5 Ribbed Belt Pulley for Coolant Pump

6 8 Nm

7 Bolt

• 50 Nm

8 Tensioning Device for Ribbed Belt

• To release tension on ribbed belt, swing using open-end wrench.

• Secure with mandrel (T10060 A)

• Removal and installation, refer to => [ Ribbed Belt Tensioner ] Service and Repair

9 Coolant Pump

• Removal and installation, refer to => [ Coolant Pump ] Service and Repair

10 Bracket for Assemblies

• Removal and installation, refer to => [ Accessory Assembly Bracket ] Service and Repair

11 Bolt

• 23 Nm

12 Generator

13 Bolt

• 3 pieces

14 A/C Compressor Fitting Sleeve

15 A/C Compressor

• Do not remove or disconnect refrigerant lines

16 25 Nm

17 Fitting Bolt

• 2 pieces

18 Idler roller

19 Bolt

• 40 Nm

Accessory Assembly Bracket Tightening Sequence





- Tighten bolts in 2 stages in - 1 to 5 - sequence as follows: