Bowden Cable For Backrest Lock, Removing and Installing

Bowden Cable For Backrest Lock, Removing And Installing







1 - Holder
2 - Holder
3 - Bowden cable adjusters (2x)
4 - Bowden cables for backrest lock (2x)
- Removing
- Remove seat.
- Attach fixture for seat repair VAS 6136 to engine and transmission holder VAS 6095.
- Attach front seat to fixture for seat repair VAS 6136.
- Remove backrest.
- Remove backrest cover panel.
- Pry out staples - 10 - (4x) on left and right.
- Remove velcro strips - 9 - (4x) on left and right. " Detach piping on side - 5 - (2x).
- Pry out piping at bottom - 9 - (3x).
- Use pliers to disengage tabs - 7 - (2x) at bottom left and right.
- Use screwdriver to pry Bowden cables out of mounts - 6 - (2x) on left and right.
- Remove Bowden cables - 4 - (2x) upward.
- Push cover - 11 - upward in direction of - arrow -.
- Detach Bowden cables at holders - 1 - and - 2 -.
- Installing
- Install Bowden cables for backrest lock in reverse order of removal.
- Set Bowden cables - 4 - (2x) with adjusters - 3 - (2x). Make sure pins at bottom left and right are released simultaneously on actuating easy-entry facility handle - 12 -.
5 - Side piping (2x)
6 - Mounts (2x)
7 - Tabs (2x)
8 - Bottom piping (3x)
9 - Velcro strips (4x) on left and right
10 - Staples (4x) on left and right
- Commercially available. -Only use upholstery stapler.
11 - Cover
12 - Handle of easy-entry facility