Drive Belt: Locations

Ribbed belt, component overview

Note:
^ Before removing ribbed belt, mark the turning direction on it with chalk or a felt tip pen. A reversed turning direction can cause damage to the belt under operating conditions. When installing, make sure the belt is correctly seated in the belt pulley.





1 - Ribbed belt
^ Check for wear
^ Do not kink

2 - Pulley
^ For ribbed belt

3 - Special bolt
^ Replace
^ Torque specification 10 Nm plus an additional 90 °

4 - 23 Nm

5 - Engine lift eye

6 - Belt tensioner for ribbed belt
^ To release tension on ribbed belt, pivot using open-end wrench.
^ Secure tensioner with special tool Locking Tool T40098

7 - 23 Nm

8 - Bushing

9 - Bracket for assemblies

10 - 23 Nm

11 - Generator
^ To facilitate installing the generator, slightly drive back threaded bushings for retaining bolts on generator.

12 - 23 Nm

13 - Power steering pump

14 - 45 Nm
^ Insert with locking fluid
^ Observe tightening sequence

15 - Bushing
^ 2 pieces

16 - Air conditioner compressor

17 - 25 Nm

18 - Idler roller for ribbed belt
^ Note installation position

19 - 20 Nm plus an additional 90 ° (1/4 turn)
^ Replace