Internal Components

Transmission Control Module (TCM) J217 , removing and installing - 01J, Continuously Variable Transmission (CVT)

Note:
^ Observe general repair notes.
^ Refer to Rules of cleanliness for working on automatic transmissions.

Removing
The Transmission Control Module (TCM) J217 can be removed with transmission installed.

- Remove end cover.





- Remove bolts -arrows- and pull out Transmission Control Module (TCM) J217 without tilting it.
- Remove twin lip oil seal -A- from Transmission Control Module (TCM) J217.

Note:
^ When positioning Transmission Control Module (TCM) J217 , ensure sensor on control module is not damaged.

Installing
Install in reverse order of removal, note the following:

Note:
^ Replace gaskets and O-rings.





- If necessary, clean sensors -A- , -C- and -D- of soiling and metal shavings.
- Clean selector shaft.





- Before installing Transmission Control Module (TCM) J217 , coat new O-rings -A- on hydraulic control module with ATF.





- Install Transmission Control Module (TCM) J217 without canting it.
^ Harness connectors -A- , -B- and -C- on rear side of control module must engage on hydraulic control module.





- Tighten bolts -arrows-.
- Install end cover.

After connecting Transmission Control Module (TCM) J217 , the following steps must be performed:
^ Complete coding for new Transmission Control Module (TCM) J217.
^ Perform adaptation for Transmission Control Module (TCM) J217.

Use Vehicle Diagnosis, Testing and Information System VAS 5051 for this.

Torque Specification: