Ignition Switch
Ignition Switch
Removing
- Remove Steering Column Switch Module (SCSM). Refer to => [ Steering Column Switch Module ] Steering Column Switch Module.
- Disconnect electrical harness connector at induction coil.
- Disconnect electrical connector - 1 - at ignition switch.
- Remove security coating from both screws - arrows -.
- Loosen screws - arrows - slightly and remove ignition switch from steering lock housing - 2 -.
Installing
Install in reverse order of removal, observing the following:
• Make sure that ignition switch and lock cylinder are in same position,. "Ignition ON", when installing.
- Secure screws - arrows - at steering lock housing - 2 - with security coating.
- Install Steering Column Switch Module (SCSM).