Selector Mechanism Assembly Overview
Selector Mechanism Assembly Overview
Part I
• Lubricate mounting areas and slide surfaces with Grease (G 000 450 02).
1 Ball
2 Rubber ring
3 Ball guide
4 Rubber ring
5 Washer
• Collar faces toward ball guide => [ (Item 3) Ball guide ]
6 Securing ring
• Remove ball when removing
7 Spring
8 Spacer bushing
9 Washer
10 Securing ring
11 Noise insulation
• - Arrow - on noise insulation points in direction of travel
12 Shift lever knob
• With cover
• Removing and installing, refer to => [ Shift Knob with Cover ] Shift Knob With Cover
13 Nut, 10 Nm
14 Shift lever support
15 Bolt, 6 Nm
16 Selector lever
• Offset faces toward rear
17 Bolt
18 Nut, 10 Nm
19 Shift housing
20 Joint piece
• For the selector rod/shift lever
21 Nut, 10 Nm
• Self-locking
• Replace
22 Bushing
Part II
• Lubricate mounting areas and slide surfaces with Grease (G 000 450 02).
1 Boot
• Secure it to the selector rod with commercially available adhesive
2 Washer
3 Ball socket
• To remove, bend peening on selector rod => [ (Item 22) Selector rod ]
4 Cap nut, 23 Nm
5 Ball pin
6 Ball socket
• To remove, remove retaining clip => [ (Item 12) Retaining clip ]
7 Connecting rod
• To remove, remove retaining clip => [ (Item 12) Retaining clip ]
8 Bushing
9 Bushing
10 Bolt, 20 Nm
11 Sleeve
12 Retaining clip
13 Bolt, 40 Nm
14 Push rod
• With bushing, bolt and washer
15 Internal hex bolt, 23 Nm
16 Washer
17 Shift lever support
18 Boot tensioning ring
19 Boot
• Carefully pull over the selector rod => [ (Item 22) Selector rod ] and push rod => [ (Item 14) Push rod ] when removing
• When installing, place on the markings on the selector rod => [ (Item 22) Selector rod ] and the push rod => [ (Item 14) Push rod ]
20 Internal hex bolt, 23 Nm
21 Clamping piece
22 Selector rod
23 Joint piece
• For selector rod/shift lever
24 Cap nut, 20 Nm
25 Selector shaft lever