Turn Signal Switch: Service and Repair

Turn Signal Switch E2 , Removing And Installing

Removing

- Remove steering column switch module.

CAUTION:
- Ensure steering is in straight ahead and centered prior to removing spiral spring.
- Position of spiral spring must not be changed once removed.







- Carefully release clip fasteners - arrows - and remove spiral spring - 1 - from steering column switch module.







- Remove Steering Angle Sensor G85 - 1 - from Steering Column Electronic Systems Control Module J527 in direction of - arrow - .







- Remove screws - arrows - .
- Remove the Steering Column Electronics Systems Control Module J527 - 2 - and Windshield Wiper/Washer Switch E22 - 3 - from steering column switch module.
- Remove Cruise Control Switch E45 - 1 - from steering column switch module.
- Remove screw - 5 - and remove retaining clip - 4 - .

Installing

Further Install in reverse order of removal, noting the following:
- Ensure all fasteners and electrical connectors are properly connected and locked into place.
- Install steering column switch module .

Tightening torques

Steering column switch module to Steering Column Electronics Systems Control Module J527 : 0.6 Nm
Intermittent wiper switch E22 to Steering Column Electronics Systems Control Module J527 : 0.6 Nm
Cruise Control Switch E45 to Steering Column Electronic Systems Control Module J527 : 0.6 Nm