Manual Entry Assistance

Front Seats

• From 06.2006, the usual wiring harness routing to connector station under front seat. Refer to => [ Connectors, Disconnecting ] Front Seats has been replaced with modular wiring routing => [ Modular Wiring Routing Assembly Overview, from June 2006 ] Front Seats.

• The modular wiring routing has not been implemented for all countries.

• Check version of front seat and of vehicle and perform repairs accordingly.

• Note the two possible versions of the modular wiring routing, Modular Light or Modular. Refer to => [ Modular Wiring Routing Versions ] Front Seats.

Manual Entry Assistance





1 - Lever

2 - Pins (Qty. 2)

3 - Manual Entry Assist

• Removing

- Move the front seat all the way forward.

- Remove seat.

- Remove the rivet - 4 - on the seat rail - 5 - and remove the metal bracket (Qty. 2) on the inner side of the seat rail - 5 -.

- Push the lever - 1 - until the pins - 2 - (Qty. 2) are inside the seat rail - 5 - and then pull the seat rail - 5 - in direction of arrow.

- Remove the manual entry assist- 3 -.

• Installing

- Guide the manual entry assist into the guide rails. Refer to => [ Guiding the manual entry assist into the guide rail ].

- Install the manual entry assist - 3 - in the reverse order of removal.

4 - Rivet

5 - Seat rail

6 - Seat Forward/Back Adjustment Handle

Guiding the manual entry assist into the guide rail





- Guide the manual entry assist - 2 - into the guide rail - 3 -.

- Press the lever - 1 - and push the manual entry assist - 2 - forward.