Air Cleaner Housing: Locations

Air Filter, Assembly Overview







1 - Not installed
2 - Air guide hose
- To turbocharger
- Check the air duct hose for dirt and leaves
3 - Hose clamp
4 - Mass air flow (MAF) sensor G70
5 - Bolt
- 1.5 Nm
6 - Air duct
- To lock carrier
7 - Bolt
- 1.5 Nm
- On lock carrier
8 - Air duct
- To air filter housing
- Clean the air channel of debris and leaves
9 - Spreader clip
10 - Bolt
- 1.5 Nm
11 - Upper part of air filter housing
- Clean air filter housing-upper part of salt residue, dirt and leaves
12 - Heat shield
13 - Bolt
- 1.5 Nm
14 - Air filter element
- Always use a genuine air filter element
- Observe change intervals
15 - Lower part of air filter housing
- Clean the air filter housing-lower part of salt residue, dirt and leaves
- Using pressurized air, blow out the water drain (small hole) in the lower part of the air filter housing.
16 - O-ring
- Replace if damaged
17 - Not installed