Protective Moldings

Protective Moldings

• Protective moldings cannot be removed without destroying them.

- To remove protective moldings - 1 - and - 2 -, heat using a hot air blower and pull off from door.





- Adhesion surface must be free of dust and grease.

- Clean outer panel with mineral spirits, treat with silicone remover and rub dry.

• Protective moldings must be affixed only at room temperature.

• For this purpose, bring vehicle and protective moldings to room temperature at least 2 hours before processing.

• Protective moldings must be adhered within 90 minutes after protective foil has been removed.

- Pull protective foil - 3 - from double-sided adhesive tape - 4 - shortly before installation.





- Apply protective molding to be adhered at front and adhere working toward rear.

- Heat protective molding to approx. 40°C using heat gun and forcefully press on or roll on.

• After adhering strip, leave vehicle 4 hours in room temperature.