Seat

Seat

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1332)





• The RS sport seat has no side airbag. Therefore, the electrical connection for the side airbag must have a terminal resistance in the wiring harness.

• Depending on the version, this terminal resistance is securely connected to the wiring harness, or is designed as a separate connector housing with terminal resistance. Refer to => [ Connector Housing with Side Airbag Terminal Resistance ] Front RS Sport Seat.





1 Front Seat

Removing

- Push front seat - 1 - fully upward and to the rear.

- Remove front bolts - 3 - (Qty. 2).

- Move seat forward.

- Loosen seatbelt eyelet at outer anchoring point for seat and remove seatbelt from belt guide.

- Remove rear bolts - 4 - (Qty. 2).

- Tip front seat - 1 - back.

- Disconnect electrical harness connectors. Refer to => [ Connectors, Disconnecting ] Front RS Sport Seat.

Installing

To install, perform the steps used in removal in reverse order.

2 Seat Rail Covers

• Right front and left rear are identical

• Left front and right rear are identical

• Removing and Installing, refer to => [ Seat Rail Covers ]

3 Front Bolts (Qty. 2)

• Tightening specification 50 Nm

4 Rear Bolts (Qty. 2)

• Tightening specification 50 Nm