Input Shaft Adjustment (Air Gap), Checking

Input shaft adjustment (air gap), checking - 01J, Continuously Variable Transmission (CVT)

CAUTION!
Do not allow engine to run without filling ATF and do not tow the vehicle.

^ ATF filled

- Drive vehicle off hoist.

Note:
^ On vehicles with air suspension, vehicle lifting mode must be deactivated.

^ ATF filled

- Place vehicle on level surface.

Note:
^ With parking brake released, vehicle may roll forward or backward by itself when in selector lever position "N".

- Start engine.

- Place selector lever in position "N".

^ Do not engage parking brake.

^ Do not operate brake pedal.

- Press accelerator.

^ Vehicle should not be allowed to roll.

If vehicle rolls in selector lever position "N":
- Adjust selector lever cable.

If selector lever cable adjustment is OK but vehicle still rolls in selector lever position "N":
- Input shaft, servicing refer to Input shaft, servicing with 6 lining discs or refer to Input shaft, servicing with 7 lining discs

Note:
^ In this case, input shaft adjustment (air gap) was not performed correctly.

If vehicle does not roll in selector lever position "N":
The input shaft adjustment with evaluation of air play is OK.

- Carry out ATF flush