Glove Compartment Cover Remote Control Unlock Motor

Glove Compartment Cover Remote Control Unlock Motor

Removing





- Switch off ignition and remove ignition key.

- Remove glove compartment. Refer to => [ Glove Compartment ] Glove Compartment.

- Disconnect the connector - 1 -.

- Remove screws - arrows - and remove remote control glove compartment unlocking positioning motor - 2 - together with cover.

- Remove cable - 3 - with adjusting nut on bracket in cover.





- Remove cover - 2 - from remote control glove compartment unlocking positioning motor - 1 -.

- Turn cable - 3 - and press nipple - 2 - out of operating rod - 1 - on remote control glove compartment unlocking positioning motor.





- Remove cable.

Installation

Installation is reverse of removal, but note the following:

- Adjust glove compartment cover cable. Refer to => [ Glove Compartment Cover Cable, Adjusting ] Glove Compartment Cover Cable, Adjusting.

- Install glove compartment. Refer to => [ Installing ] Glove Compartment.

Tightening Specifications