DVD Player Retaining Plate

Power Front Memory Seats

• From 07.2006, the usual wiring harness routing to connector station under front seat => [ Connectors, Disconnecting ] Power Front Memory Seats Overview has been replaced with modular wiring routing => [ Modular Wiring Routing, from 07.2006, Assembly Overview ] Standard Front Seats Overview.

• The modular wiring routing has not been implemented for all countries.

• Check version of front seat and of vehicle and perform repairs accordingly.

• Note the two possible versions of the modular wiring routing, Modular Light or Modular => [ Modular Wiring Routing Versions ] Standard Front Seats Overview.



DVD Player Retaining Plate

Removing





- Remove front backrest cover and upholstery => [ Seat Pan Cover and Upholstery, Standard Seat ] Front Seat Covers and Upholstery, Power Memory Seats.

- Remove the bolts - 2 -.

- Remove the retaining plate - 3 - for the screen console.

- Loosen nut - 2 -.





- Guide the socket - 4 - and washer - 3 - out of the mount - 1 -.

Installing

Installation is reverse of removal, noting the following:

- Pull the washer - 3 - up and slide the socket - 4 - from the side into the mount - 1 -.

• The socket must fit in the center of the mount.

- Hold the socket in this position and tighten the nut.

- Install the retaining plate hooks into the backrest frame - 1 - - arrows -.





- Tighten the bolts.

Tightening Specifications