Lumbar Support Adjustment Motors, Old Version

Standard Front Seats

• From 07.2006, the usual wiring harness routing to connector station under front seat => [ Connectors, Disconnecting ] Standard Front Seats Overview has been replaced with modular wiring routing => [ Modular Wiring Routing, from 07.2006, Assembly Overview ] Standard Front Seats Overview.

• The modular wiring routing has not been implemented for all countries.



Lumbar Support Adjustment Motors, Old Version

Special tools, testers and auxiliary items required

• Engine and transmission holder (VAS 6095)

• Fixture for seat repair (VAS 6136)

• In driver's seat illustrated, the motor for lumbar support height adjustment is on the left side and motor for lumbar support adjustment is on the right side.





1 Bracket

2 Hook

3 Lumbar support height adjustment release

4 Four-way lumbar support

5 Retainer

6 Hook

7 Retaining plate

8 Rivets (Qty. 4)

9 Lumbar support adjustment motors (Qty. 2)

• Removing

- Remove seat => [ Standard Front Seat ].

- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).

- Attach the front seat to the fixture for seat repair (VAS 6136).

- Remove backrest cover panel => [ Backrest Cover ].

When removing lumbar support height adjustment motor:

- Remove side airbag => [ Front Airbag Igniters, Standard Power Seat ] .

- Disconnect connector - 10 -.

- Drill out rivets - 8 - (Qty. 2) on outer side.

- Disengage release - 3 - on hook - 6 - from retaining plate - 7 -.

- Guide release - 3 - out of bracket - 5 -.

When removing lumbar support adjustment motor:

- Disconnect connector - 10 -.

- Drill out rivets - 8 - (Qty. 2) on outer side.

- Disengage release - 11 - on hook - 2 - out of four-way lumbar support - 4 -.

- Disengage the release cable - 11 - from the bracket - 1 -.

• Installing

To install, perform the steps used in removal in reverse order.

10 Connectors (Qty. 2)

11 Lumbar support adjustment release