Ribbed Belt

Ribbed Belt

Removing

- Remove sound insulation by loosening securing pieces - 1, 2 and arrow -.





- Remove electrical harness connector - 2 - from bracket and disconnect it.





- Release retaining clip - arrow - and lay aside Coolant Fan Control (FC) Control Module (J293) - 1 -.

CAUTION!
Risk of destroying due to reversed running direction on a used ribbed belt.

• Before removing ribbed belt, marking running direction with chalk or felt-tip pen for reinstallation later.

- Pivot tensioning device in direction of - arrow - to relieve tension on ribbed belt.





- Remove ribbed belt and release tensioning device.

Installing

Installation is in reverse order of removal, note the following:

- Route ribbed belt - 2 - over belt pulley in specified sequence.





1 Generator
3 Idler roller
4 Vibration damper
5 Tensioning roller

• When installing the ribbed belt, ensure it is seated correctly on the pulleys.

- Start engine and check running belt.