Seat Height Adjustment Handle

Standard Front Seats

• From 07.2006, the usual wiring harness routing to connector station under front seat => [ Connectors, Disconnecting ] Standard Front Seats Overview has been replaced with modular wiring routing => [ Modular Wiring Routing, from 07.2006, Assembly Overview ] Standard Front Seats Overview.

• The modular wiring routing has not been implemented for all countries.


Seat Height Adjustment Handle





1 Seat height adjustment handle

- Create an assisting tool => [ Preparing assist tool to remove seat height
adjusting handle ].

- Pull seat height adjustment handle - 1 - away from seat a little.

- Guide assisting tool - 2 - into mount -4-.

- Pull assisting tool - 2 - in - direction of arrow A - to push spring - 3 - back.

- Pull seat height adjustment handle - 1 - in - direction of arrow B -.

• Installing

To install, perform the steps used in removal in reverse order. When doing so, note the following:

- Make sure the clip is mounting on the lever for the seat height adjustment. Note installation position => [ Retaining clamp installation position ].

2 Assisting tool

3 Spring

4 Mount

Preparing assist tool to remove seat height adjusting handle





- Bend a screwdriver - 1 - with a width - 2 - of 3.5 mm and dimensions - A - 20 mm and - B - max. 15 mm.

Retaining clamp installation position





- Make sure the clip springs - 2 - (Qty. 2) - 3 - are positioned on outside of lever - 1 -.