Operation CHARM: Car repair manuals for everyone.

Fuel Tank with Attachments Assembly Overview






Fuel Tank with Attachments Assembly Overview





1 Bolt, 23 Nm

2 Suspended Mount

For exhaust system.

3 Carrier Plate

4 Fuel Line

From fuel filter to engine.

Do not kink.

To disconnect, press release button on connection piece.

5 Vent Line

From EVAP canister to Evaporative Emission (EVAP) Canister Purge Regulator Valve (N80).

Do not kink.

To disconnect, press release button on connection piece.

Clipped in on fuel tank.

6 Bolt, 23 Nm

Serves to secure fuel filler neck and ground (GND) connection - item 11 -.

7 Overflow Hose

Hooked onto the wheel housing liner.

8 Rubber Gasket

9 Gasket

Replace if damaged.

10 Cap

Attached to tank flap unit with fastening device.

11 Ground Connection

For discharging electrostatic charge.

Installed location, refer to => [ Installation Position of Ground (GND) Connection ]

Ensure connectors are securely seated and wiring is fastened with the bolt for fuel filler tube - item 6 -.

After installing, check electrical connection of metal ring at fuel filler tube to a bare area of chassis using Ohm meter - Specified value: approximately 0ohms.

12 Vent Line

13 Vent Line

To EVAP canister.

14 Fuel Tank

Removing and installing, refer to => [ Fuel Tank with Attachments ] Fuel Tank with Attachments.

15 Securing Strap

16 Spreader Clip

17 Bolt, 23 Nm

18 Heat Shield for Fuel Tank

19 Nut, 2 Nm

Fuel Pump Control Module Bracket to Body, Tightening Specification





- Tighten bolts - arrows - to 4 Nm.

Installation Position of Ground (GND) Connection





- Route Ground (GND) connection as shown in figure.

- First, engage the ground connection contact - 3 - into the opening on fuel tank - 4 -. Then install the bushing - 5 -.

- Ensure connector of ground (GND) connection - 1 - fits securely at metal ring - 2 - of fuel filler tube.

CAUTION!
Risk of explosion due to electrostatic charge.

After installing, check electrical connection on fuel filler neck metal ring to an empty spot on the body using an Ohm meter.

Specified value: about 0 ohms