Outer Door Sill Molding, Replacing

Outer Door Sill Molding, Replacing

• Outer door sill molding cannot be removed without destroying it.

• Door sill moldings must be affixed only at room temperature.

• For this purpose, bring vehicle and door sill moldings to room temperature at least 2 hours before processing.

• Protective moldings must be adhered within 90 minutes after protective foil has been removed.

• After adhering strip, leave vehicle 4 hours in room temperature.





1 Front sill panel trim

- Heat door sill molding using a hot air gun and carefully pull upward and off

- Clean adhesion surface with mineral spirits, treat with silicone remover and rub dry.

- Heat adhesion surface to approx. 40 ? using a hot air gun.

- Pull protective foil from double-sided adhesive tape shortly before installation.

- Clip in door sill molding and press on.

2 Rear sill panel trim

- Heat door sill molding using a hot air gun and carefully pull upward and off

- Clean adhesion surface with mineral spirits, treat with silicone remover and rub dry.

- Heat adhesion surface to approx. 40 ? using a hot air gun.

- Pull protective foil from double-sided adhesive tape shortly before installation.

- Clip in door sill molding and press on.