Rear Center Console

Rear Center Console

Special tools, testers and auxiliary items required

• Special hook (3370)

• Trim removal wedge (3409)

• Hook (3438)

Removing





- Pry screw cover cap - 2 - off with screwdriver.

- Remove screw.

- Unclip center console right side trim - 1 - with (3409) and pull up and out.

- Pry screw cover cap - 1 - off with screwdriver.





- Remove screw.

- Unclip center console left side trim - 2 - with (3409) and pull up and out.

- Place rear center console vent blades horizontally.





• The rear center console vent has holes to hang the (3438).

- Remove rear center console vent with (3438) in - direction of arrow -.

- Disconnect the connector from the rear center console vent.

Vehicles with front center armrest:





- If applicable, disconnect electrical connectors - 1 - and - 2 -.

- Remove screws - arrows -.

- Pull front center armrest up and out.

Vehicles with rear cup holder:





- Remove inlay mat.

- Remove screws - arrows -.

- Remove rear cup holder from rear center console.

All:





- Lift rear storage compartment inlay mat out of rear center console using (3370) in - direction of arrow -.

- Disconnect the connector - 2 -.





- Remove the bolts - 1 -.

- Disengage left and right of rear center console, push catches - 3 - and lift rear center console up and out.

- If applicable, disconnect rear seat heating rotary knob electrical connections.

Installation

Installation is reverse of removal, but note the following:

- When inserting rear center console, ensure that both left and right locking tabs engage correctly.

Tightening Specifications