Power Locks: Locations
Central Locking System
Component overview, Sedan
1 - Right front door control module J387
- Integrated in window regulator.
2 - Right Rear Door Control Module J389
- Integrated in window regulator.
3 - Motor for fuel tank lid release V155
- Removal
4 - Central control module for comfort system J393
- Component location, in right rear side panel.
5 - Motor for rear lid release V139
6 - Left Rear Door Control Module J388
- Integrated in window regulator.
7 - Driver's Door Control Module J386
- Integrated in window regulator.
8 - Front hood switch F266
- Component location in lock carrier
Component overview, Avant
1 - Front Passenger's Door Control Module J387
2 - Right Rear Door Control Module J389
3 - Motor for fuel tank lid release V155
- Removal
4 - Central control module for comfort system J393
- Component location, in right rear side panel.
- Removing and installing
5 - Motor for rear lid release V139
6 - Rear Lid Control Module J605
7 - Left Rear Window Shade Control Module J765
8 - Left Rear Door Control Module J388
9 - Drivers Door Control Module J386
10 - Front hood switch F266
- Component location in lock carrier
Front Door Control Module Installation Position
- To install, insert door control module - 1 - in lower mounting points, swing upward and engage.
- Window regulator motor - 2 -.
Rear Door Control Module Installation Position
- To install, insert door control module - 1 - in lower mounting points, swing upward and engage.
Remove Fuel Tank Lid Unlock Motor -V155-
Special Tools, Testers And Auxiliary Items Required
- Socket wrench T10010.
1 - Motor for fuel tank lid release
- Side trim on right side of luggage compartment removed.
- Disconnect electrical harness connector to motor.
- Loosen bolts - arrow - turning toward right using socket wrench T10010 and slide motor - 1 - out of oblong holes.
- Before installing new motor, you must first slide emergency release eye - 4 - over locking pin.
NOTE:
- For easier installation, slide an appropriate hose - 5 - from outside to inside as an assisting tool in luggage compartment.
- Place hose - 5 - on operating rod - 4 - and pull outward in tank cup.
- Slide motor into oblong holes and tighten screws to 2 Nm by turning to left
2 - Securing clip
3 - Operating rod
4 - Cable for emergency release
- Window regulator motor - 2 -.