Exterior Rearview Mirror Overview
Exterior Rearview Mirror
=> [ Exterior Rearview Mirror Assembly Overview ]
=> [ Mirror Housing Assembly Overview ]
Exterior Rearview Mirror Assembly Overview
1 - Mirror housing
• May be removed from door without removing entire exterior rearview mirror. Refer to=> [ Mirror Housing ] Exterior Rearview Mirror.
2 - Adjusting motor
• Removal, refer to=> [ Mirror Adjusting Motor ] Exterior Rearview Mirror
3 - Mirror adjusting unit
• Before replacing, window frame must be removed.
• Before removing, remove exterior rearview mirror from door
• To remove, pry off the mirror glass, disconnect the connectors for the mirror heating - 6 -, remove the Phillips head screws and remove the mirror adjustment unit from the mirror housing - 1 -.
4 - Mirror glass
• Use special tool 80-200 (pry lever) to unclip.
• Protect mirror housing against damage using textile tape above and below.
• Press mirror lens first downward, then upward.
• To install mirror lens into guide pins and friction finger, insert into friction spring and press on.
• Apply pressure only on center of glass, wear protective gloves while doing so.
5 - Connector
• Clip connector into catch - arrow -on rear side of mirror.
6 - Mirror heating electrical connection
7 - Electrical connection
8 - Combination screw
• 12 Nm
9 - Front Door
10 - Seal
• Ensure correct seating when installing.
11 - Mirror base
Mirror Housing Assembly Overview
1 - Mirror housing
• Removal:
- Mirror glass removed
- Remove bolts - 4 - from cover trim - 3 - and remove them downward.
- Release housing from locking tabs on mirror adjusting unit and remove it upward.
• Installing
- Position mirror housing onto mirror adjusting unit - 2 - from above.
- While doing so, locking tabs - arrows - in mirror adjusting unit must engage above and below => [ Lower mirror locking tab ] Exterior Rearview Mirror.
2 - Mirror adjusting unit
3 - Lower trim strip.
4 - Combination screw
• 1 Nm
Lower mirror locking tab
- When installing, locking tab (arrow - A -) of mirror adjusting unit - 2 - must be inserted into mirror housing catches - 1 - in direction of - arrow -.