Engine, Securing to Engine and Transmission Holder

Engine, Securing to Engine and Transmission Holder

Special tools, testers and auxiliary items required

• Lifting Tackle (2024 A)

• Engine and Transmission Holder (VAS 6095) with Bracket (VAS 6095/1-5)

• Shop Crane (VAS 6100)

• Lift Arm Extension for Workshop Crane (VAS 6101)

Procedure

• Engine separated from transmission. Refer to => [ Engine and Multitronic Transmission, Separating ] Engine and Multitronic Transmission, Separating and=> [ Engine and Automatic Transmission, Separating ] .

- Hook Engine Sling (2024 A) onto engine and onto Workshop Crane (VAS 6100) with Lift Arm Extension for Workshop Crane (VAS 6101) as shown in the illustration.





• To be aligned to the center of gravity of the engine assembly, the hole rails of the lifting hook must be inserted as shown in the illustration.

CAUTION!
Lifting hooks and alignment pins on the engine sling must be secured with securing pins - arrows -.

- Disconnect the connector - 1 - on the Left Electron-Hydraulic Engine Mount Solenoid Valve (N144), if equipped.





- Remove bolts - arrows - and remove left engine mount.

• Shown without engine mount bracket to provide a better illustration.

With manual and multitronic transmission:

- Repeat work procedure on opposite side of the engine.

All Vehicles

- Secure engine using Bracket (VAS 6095/1-5) to 40 Nm Engine and Transmission Holder (VAS 6095) as shown in illustration.