Coolant Pump

Coolant Pump

Special tools, testers and auxiliary items required

• Spanner Wrench (3212)

Removing

- Drain the coolant. Refer to => [ Cooling System, Draining and Filling ] Procedures.

- Pull front engine cover off - arrows -.





• Before removing the ribbed belt, mark the turning direction on it with chalk or a felt tip pen. A reversed turning direction can cause damage to the belt under operating conditions.

- Pivot tensioning device in direction of - arrow - to relieve tension on ribbed belt.





- Remove the ribbed belt from the coolant pump.

- Release the tensioner unit

- Remove the ribbed belt pulley from the coolant pump.





- When loosening bolts use Spanner Wrench (3212) to counter-hold.

- Pry off cover cap.





- Remove bolt - arrows - and disconnect idler roller.

- Remove bolts - arrows - for coolant pump and remove coolant pump.





Installing

Installation is in reverse order of removal, note the following:

- Clean sealing surfaces so they are completely free of any oil or grease.

- Install ribbed belt. Refer to => [ Ribbed Belt ] Ribbed Belt.

- Fill with coolant => [ Filling ] Procedures.

Tightening Specifications