Body Emblem
Emblem
=> [ Sedan ]
=> [ Avant ]
Sedan
CAUTION!
• The adhesive surfaces on the body must be free of dirt and grease.
• Clean the adhesive surfaces using cleaning solution (D 009 401 04).
• Warm the adhesive areas and the name plate to approximately 104°F (40°C) using a hot air gun.
• Press the name plate with the roller (T10314) after installing.
Special tools, testers and auxiliary items required
• Roller (T10314)
• Hot air gun (V.A.G 1416)
Dimensional data for Front-Wheel Drive (FWD) vehicles
• Outer edges of rear lid and lines extending from lower rear lights are used as reference edges.
• - a - = 31 mm.
• - b - = 19 mm.
• - c - = 31 mm.
• - d - = 16 mm.
• Peel off the protective film, mount the name plate according to the specifications and press it firmly on.
Dimensional data for All Wheel Drive (AWD) vehicles
- Peel off the protective film, mount the name plate according to the specifications and press it firmly on.
• - a - = 31 mm.
• - b - = 19 mm.
• - c - = 4 mm.
• - d - = 36 mm.
• - e - = 16 mm
- Dimension - e -must be measured for upward extension of lower badge.
S6 dimensional data
• - a - = 15 mm.
• - b - = 31 mm.
• - c - = 89 mm.
Dimensional data for lettering on fender
- Peel off the protective film, mount the name plate according to the specifications and press it firmly on.
• - a - = 56 mm.
• - b - = 58 mm.
• - c - = 33 mm.
• - d - = 109 mm
Vehicles without side turn signals
• - a - = 148.5 mm
• - b - = 145 mm
• - c - = 87 mm
• - d - = 77 mm
• Peel off the protective film, mount the name plate according to the specifications and press it firmly on.
S-line name plate
• - a - = 73mm
• - b - = 74mm
• - c - = 58 mm
- Peel off the protective film, mount the name plate according to the specifications and press it firmly on.
Super charged name plate
• - a - = 146 mm
• - b - = 151 mm
• - c - = 205 mm
• Peel off the protective film, mount the name plate according to the specifications and press it firmly on.
Avant
CAUTION!
• The adhesive surfaces on the body must be free of dirt and grease.
• Clean the adhesive surfaces using cleaning solution (D 009 401 04).
• Warm the adhesive areas and the name plate to approximately 104°F (40°C) using a hot air gun.
• Press the name plate with the roller (T10314) after installing.
Special tools, testers and auxiliary items required
• Roller (T10314)
• Hot air gun (V.A.G 1416)
Dimensional data for Front-Wheel Drive (FWD) vehicles
• Outer edges of rear lid and lines extending from lower rear lights are used as reference edges.
- Peel off the protective film, mount the name plate according to the specifications and press it firmly on.
• - a - = 55 mm
• - b - = 38 mm
• - c - = 55 mm
• - d - = 83 mm
Dimensional data for All Wheel Drive (AWD) vehicles
• - a - = 55 mm
• - b - = 38 mm
• - c - = 55 mm
• - d - = 83 mm
• - e - = 4 mm
• - f - = 60 mm
• Peel off the protective film, mount the name plate according to the specifications and press it firmly on.