Seat Height Adjustment Motor

Power Memory Front Seats

Seat Height Adjustment Motor





1 - Screw

• Quantity: 2

• 20 Nm

2 - Screw

• Quantity: 2

• 18 Nm

3 - Shoulder pin

• 25 Nm

4 - Nut

• 25 Nm

5 - Seat height adjustment motor

• Removing

- Remove seat. Seat

- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).

- Attach the front seat to the fixture for seat repair (VAS 6136).

- Remove side trim on sill side. Side Trim, Sill Side

- Remove side trim on tunnel side. Side Trim, Tunnel Side

- Remove the cover - 7 -.

- Remove the bolts - 1 - (Qty. 2) for securing the seat upper frame to the lower frame.

- Remove the bolts - 2 - (Qty. 2).

- Remove the shoulder pin - 3 - and the nut - 4 -.

- Tip the seat upper frame - 6 - forward.

CAUTION!
Injury can result if the seat upper frame tips back. Secure the seat upper frame against tipping back.

- Loosen the electrical connector on the seat height adjustment motor and remove the motor.

• Installing

- Position the motor - 1 - with the pins - A - (Qty. 2) in the corresponding mount.

- Tighten the motor.

- Tilt the seat upper frame down and guide the toothed segment - 3 - into the seat height adjustment motor.

CAUTION!
Do not damage the bearing bushing - 2 - when inserting the nut and the shoulder pin.

- Insert the nut.

- Tighten the shoulder pin.

- Tighten the bolts connecting the seat upper frame to the lower frame.

- Finish the rest of the procedure.

6 - Seat upper frame

7 - Cover

Replacing the motor